Front brake disc pad check (Every 6000 miles or 6 months)

1 Place a mirror between the roadwheel and the caliper and check the thickness of the friction material of the disc pads (see illustration). If the material has worn down to the specified minimum or less, the pads must be renewed as an axle set (four pads).

16.1 Checking the front disc pad wear using a mirror
16.1 Checking the front disc pad wear using a mirror

2 For a comprehensive check, the brake pads should be removed and cleaned. This will permit the operation of the caliper to be checked, and the condition of the brake disc itself to be examined on both sides. Refer to Chapter 9 for further information.

    See also:

    Camshafts and cam followers - removal, inspection and refitting
    Note: Once the timing chain has been removed from the camshaft sprockets, do not turn the crankshaft until the timing chain has been correctly refitted - this is to prevent contact between the val ...

    Engine - removal leaving automatic transmission in vehicle
    Note: Refer to the warning in Section 8 before proceeding. A suitable hoist and lifting tackle will be required for this operation. 1 Proceed as described in Section 9, paragraphs 1 to 17 inclusiv ...

    Cylinder head - removal and refitting (engine in vehicle)
    Note: Refer to the warning in Section 8 and the note at the beginning of Section 21 before proceeding. Removal 1 Disconnect the battery negative lead. 2 Drain the cooling system. 3 Disconnect th ...