Identifying components in the engine compartment

2.0L DOHC Zetec engine


  1. Transmission fluid dipstick (automatic transaxle)
  2. Battery
  3. Air filter assembly
  4. Engine oil filler cap
  5. Engine oil dipstick
  6. Power steering fluid reservoir
  7. Engine coolant reservoir
  8. Windshield washer fluid reservoir
  9. Brake fluid reservoir

WINDSHIELD WASHER FLUID

Check the washer fluid whenever you stop for fuel. The reservoir is highlighted with a symbol.


If the level is low, add enough fluid to fill the reservoir. In very cold weather, do not fill the reservoir all the way.

Only use a washer fluid that meets Ford specifications. Refer to Lubricant specifications in this chapter.

State or local regulations on volatile organic compounds may restrict the use of methanol, a common windshield washer antifreeze additive.

Washer fluids containing non-methanol antifreeze agents should be used only if they provide cold weather protection without damaging the vehicle's paint finish, wiper blades or washer system.

If you operate your vehicle in temperatures below 4.5Вє C (40Вє


If you operate your vehicle in temperatures below 4.5Вє C (40Вє F), use washer fluid with antifreeze protection. Failure to use washer fluid with antifreeze protection in cold weather could result in impaired windshield vision and increase the risk of injury or accident.

Note: Do not put washer fluid in the engine coolant reservoir. Washer fluid placed in the cooling system may harm engine and cooling system components.

    See also:

    Cylinder block and bores - examination and renovation
    1 The cylinder bores must be examined for taper, ovality, scoring and scratches. Start by examining the top of the bores; if these are worn, a slight ridge will be found which marks the top of the ...

    Thermo-viscous cooling fan (SOHC models) - removal and refitting
    Removal 1 Disconnect the battery negative lead. 2 Remove the four retaining clips and unscrew the two retaining screws, then withdraw the upper section of the fan shroud (see illustrations). 1 ...

    Final drive oil level check (Every 12 000 miles (20 000 km) or 12 months)
    1 Check the final drive oil level as follows. 2 Position the vehicle over a pit, or raise it at front and rear on ramps or axle stands. The vehicle must be level. 3 Wipe clean around the final dri ...