Fuses and relays

Fuses

If electrical components in the vehicle are not working, a fuse may have blown. Blown fuses are identified by a broken wire within the fuse. Check the appropriate fuses before replacing any electrical components. Note: Always replace a fuse with one that has the specified amperage


Note: Always replace a fuse with one that has the specified amperage rating. Using a fuse with a higher amperage rating can cause severe wire damage and could start a fire.

Standard fuse amperage rating and color

Passenger compartment fuse panel


Passenger compartment fuse panel

The fuses are coded as follows:


The fuses are coded as follows:


Power distribution box


Power distribution box

The power distribution box is located in the engine compartment. The power distribution box contains high-current fuses that protect your vehicle's main electrical systems from overloads.

Always disconnect the battery before servicing high current fuses.

Always replace the cover to the power distribution box before reconnecting the battery or refilling fluid reservoirs

If the battery has been disconnected and reconnected, refer to the Battery section of the Maintenance and specifications chapter.

The high-current fuses are coded as follows.


The high-current fuses are coded as follows.

Relays


Relays

Relays are located in the power distribution box and should be replaced by qualified technicians.

    See also:

    Fuel pressure regulator - removal and refitting
    Note: Refer to the precautions at the end of Section 1 before proceeding. A new sealing ring will be required on refitting. Removal 1 Disconnect the battery negative lead. 2 Depressurise the fuel ...

    Ignition switch - removal and refitting
    Pre-1986 models Removal 1 Disconnect the battery, undo the screws and remove the steering column lower shroud. 2 Insert the ignition key into the lock and turn it to position I. 3 Using a flat- ...

    Steering and suspension security check (Every 12 000 miles (20 000 km) or 12 months)
    1 Check the shock absorbers by bouncing the vehicle up and down at each corner in turn. When released, it should come to rest within one complete oscillation. Continued movement, or squeaking and ...