Hydraulic pipes and hoses - renewal

Note: Before starting work, refer to the warning at the beginning of Section 3 concerning the dangers of hydraulic fluid.

1 Always disconnect a flexible hose by prising out the spring anchor clip from the support bracket and then, using two closefitting spanners, disconnect the rigid line from the flexible hose (see illustration).

15.1 Removing a flexible hose spring anchor clip
15.1 Removing a flexible hose spring anchor clip

2 Once disconnected from the rigid pipe, the flexible hose may be unscrewed from the caliper or wheel cylinder.

3 When reconnecting pipelines, or hose fittings, remember that all union threads are to metric sizes. No copper washers are used at unions and the seal is made at the swaged end of the pipe, so do not try to wind a union in if it is tight yet still stands proud of the surface into which it is screwed.

4 A flexible hose must never be installed twisted, but a slight “set” is permissible to give it clearance from an adjacent component. Do this by turning the hose slightly before inserting the bracket spring clip.

5 Rigid pipelines can be made to pattern by factors supplying brake components.

6 If you are making up a brake pipe yourself, observe the following essential requirements.

7 Before flaring the ends of the pipe, trim back the protective plastic coating by a distance of 5.0 mm.

8 Flare the end of the pipe as shown (see illustration).

15.8 Brake pipe flare
15.8 Brake pipe flare

A Protective coating removed before flaring

9 The minimum pipe bend radius is 12.0 mm, but bends of less than 20.0 mm should be avoided if possible.

    See also:

    Distributor components (CVH models) - removal and refitting
    1 The distributor fitted to the CVH engine is unlike any conventional distributor, in that it has no main body and no adjustments are possible. The distributor is used purely to distribute HT volt ...

    Rear disc caliper - removal, overhaul and refitting
    Note: Complete dismantling of the rear caliper should not be attempted unless Ford spring compressor (tool No 12-007) is available, or unless the problems likely to arise in the absence of the too ...

    Rear stub axle carrier Saloon and Estate models) - removal and refitting
    Removal 1 Raise and support the rear of the car on stands (see “Jacking and Vehicle Support”). Remove the roadwheel. 2 Remove the rear hub as described in Section 9. 3 Remove the rear brake shoe ...